Papers by Author: A.M.K. Hafiz

Abstract: This paper presents the results of experimental investigations conducted on a vertical machining centre (VMC) using spindle speed, feed rate, and depth of cut as machining variables to ascertain the effectiveness of TiAlN insert in end milling of hardened steel AISI H13, under work-piece preheated conditions and hence a statistical model was developed using the capabilities of Response Surface Methodology (RSM) to predict the tool life. Sufficient number of experiments was conducted based on the small central composite design (CCD) concept of RSM to generate tool life data for the selected machining variables. The adequacy of the model was tested at 95% confidence interval. Meanwhile, a time trend was observed in residual values between model predictions and experimental data, reflecting little deviations in tool life prediction. A very good performance of the RSM model, in terms of agreement with experimental data, was achieved. The model can be used for the analysis and prediction of the complex relationship between cutting conditions and the tool life in flat end milling of hardened materials.

Abstract: This study was conducted to investigate the effect of preheating through inductive heating mechanism in end milling of AISI D2 hardened steel (60-62 HRC) by using coated carbide tool inserts. Apart from preheating, two other machining parameters such as cutting speed and feed were varied while the depth of cut constant was kept constant. Tool wear phenomenon and machined surface finish were found to be significantly affected by preheating temperature and other two variables. End milling operation was performed on a Vertical Machining Centre (VMC). Preheating of the work material to a higher temperature range resulted in a noticeable reduction in tool wear rate leading to a longer tool life. In addition, improved surface finish was obtained with surface roughness values lower than 0.4 μm, leaving a possibility of skipping the grinding and polishing operations for certain applications.