Papers by Author: Ahmad Nazib Alias

Abstract: Polarized absorption and dielectric spectra of blended poly (N-vinlycarbazole) (PVK) with polyvinylpyrrolidone (PVP) in different composition ratiosare investigated. Polymer coating was carried out using doctor blade technique on a quartz substrate. The polarized optical source was produced by using the uv-vis sheet polarizer. The polarized absorption and dielectric spectrum for parallel and perpendicular reveal that there are different significant results obtained between PVK and PVP with various polymer compositions.The polarized optical properties such aspolarization, ρwere calculated.These spectra indicate that the anisotropic properties of each polymer blends is different from each other.

Abstract: Polymer electrolytes consist of poly(vinylidene fluoride –hexafluoropropylene) (PVDF-HFP) and lithium trifluoromethanesulfonate, LiTf (LiCF3SO3) were prepared by dissolving in dimethylformamide (DMF) using solution casting method and further dried in vacuum oven. The conductivity of each sample was investigated using electrochemical impedance spectroscopy (EIS) method. The samples were measured in two different environments viz. in humidity chamber (40% RH; 27°C) and at ambient condition (~60% RH; 27°C). The maximum conductivity obtained for the samples in humidity chamber was 8.05 × 10-5 S/cm with addition of 35 wt% of LiTf. Meanwhile, the highest conducting samples (with addition of 45 wt% of LiTf) exhibited the ambient condition temperature of 1.11 ×10-4 S/cm. Further increased salt concentration from the optimize concentration values has reduced the conductivity of the polymer electrolyte. Dielectric permittivity studies revealed that samples showed the non-Debye behaviors

Abstract: The optical and electronic structures of poly (N-carbazole) (PVK) blend with poly(vinylidene fluoride-co-hexafluoropropene) (PVDF-HFP) and polyvinylpyrrolidone (PVP) in the same composition were investigated. Polymer coating was carried out using doctor blade technique on a glass substrate. Uv-vis and photoluminescence spectrum revealed that there are significant different results obtained between PVK, PVK:PVP and PVK:PVDF-HFP. The electronic parameters such as absorption edge (Ee), allowed direct bandgap (Ed), allowed indirect bandgap (Ei) and Urbach edge (Eu) were calculated by using Tauc/Davis-Mott Model. The value of Ee and Ed for PVK and PVK:PVDF-HFP almost same but there was significant different value between Eu and Ei.