Papers by Author: Bao Shou Sun

Abstract: Injection moulding is an important manufacturing method for plastic parts. There are however many moulding quality defects caused by inappropriate setting of moulding process conditions, as well as the poorly designed plastic part geometry. Often, stiffeners are used in a plastic part to increase its strength. However, if the stiffeners are not designed properly, they will introduce one or more moulding quality problems, which in turn will worsen the part strength rather than increasing it. Although there have been quite a lot of researches on optimising moulding quality, it is often difficult to minimize multiple quality defects simultaneously. In this paper, we propose to employ flow uniformity as the optimisation objective to address this problem. A number of stiffener layout designs are evaluated in terms of this objective to determine the best design, where standard deviations of filling times and pressures at the extremities of the plastic part are used to measure the uniformity of flow. A simple case study is also presented to demonstrate the applicability of the proposed methodology.

Abstract: In this paper, the simulation model of the cold rolling process of the deep groove bearing inner ring was established by using the finite element software Deform-3D. The numerical calculation of the model was made with different process parameters. The law of the influence the process parameters on the rolling force was analyzed. The deformation mechanism of the cold rolling process of the inner ring was revealed. The research indicated that the feed rate of idle roller had the greatest influence on the cold rolling process. Finally the experiment using the XS-50 precision CN ring rolling machine was carried on and a finished product of the inner ring of a better quality came out. It verified that the numerical simulation could provide theoretical basis for the practical production process.

Abstract: In this paper, Taguchi experimental design method is applied, and injection molding CAE simulation analysis is conducted. Influence factors of warpage of products are analyzed. According to the results of ranking, influence factors of warpag are the packing pressure, packing time, melt temperature and mold temperature. The packing pressure is the most important influence factor. To get the best level combination of various factors, mixed level orthogonal experimental design is applied to the optimization. Optimal levels of combination process parameters are obtained and the quality of injection products is greatly improved.

Abstract: 3D model of 6006 gulley ball bearing inner ring is established in this paper. Based on the study of finite element numerical simulation on the cold rolling process of inner ring by Deform-3D software, the paper shows the influence of the feed rate of idle roller, rotational rate of driving roller as well as wide-diameter ratio on the rules of rolling forming of bearing inner ring. Through the research of numerical simulation, it is discovered that feed rate of idle roller and wide diameter ratio have a greater impact on the ring end surface quality larger than rotational rate of driving roller does. Thus, process parameters should be chosen reasonably according to mold parameters and material parameters, which will help improve the stability of the cold rolling process and the rolling production efficiency.