Papers by Author: Cheng Yong Wang

Abstract: Some technologies of ultra-precision single-plane polishing and lapping devices, including spindle section, polishing pad, cooling system, dressing system and pressurization system are discussed. The development trends of ultra-precision single-plane polishing and lapping devices are also analyszed as more controllable, integrated and high-precision in the future.

Abstract: Microburrs have great influence on printed circuit board’s quality. PCB is composed of glass fiber plastic reinforcement material and copper foil. The PCB microburrs are generated in copper foil drilling process. These burrs are generated by copper extrusion and accumulation around the micro-hole. Enter burr and exit burr is quite different. Enter burrs are lower than exit burrs. The burr formation experienced three stages: First, Copper foil extrudes with the feed of microdrill; Second, Most of the Materials are cut off by drill tip and the rest of material; At last, rollover burrs appear when drill enters or exits uncut chip rolls.

Abstract: Printed circuit board (PCB) composed of glass fiber reinforcement plastic and copper foil is a kind of typical composite material. The cutting process of fiber reinforcement plastic materials such as carbon fiber or glass fiber reinforcement plastic materials have been studied for many years, but the drilling process of printed circuit board using microdrill is more complicated than common carbon fiber reinforcement plastic materials. It is event that the cutting force changed when drill different material. The variation of drilling force may cause some problems such as drill break, board delamination. So it is important to study the drilling force in PCB drilling. The precision dy-namometer was used in experiments and cutting process was analyzed in this paper. The drilling process of PCB experience six stages and the drill will meet aluminum board, glass fiber reinforce-ment plastic (GFRP) and base strip. According to the drilling force in one circle, the peak force ap-peared at the moment of drilling copper foil and another smaller peak force appeared at the moment of drilling aluminum board and base board. The experiment results show that thrust force increased with federate and decreased with rotational speed.

Abstract: There are some defects such as delamination and tools chipping etc. in drilling Ti/Carbon fibre interlaminated composites. To look for countermeasures, a special drill is developed considering tool material, geometry, coatings, cutting edge strengthening and drilling technology. The drill is comparable with imported tools as far as holes quality, efficiency and life are concerned. It is highly appreciated by customers.

Abstract: This work is focused on the investigation of the influence of the materials of PCB, feed rate, spindle speed and tool wear on thrust force when drilling PCB using 0.3 mm diameter cemented tungsten carbide drills. The results indicate that thrust force increases with feed rate and drill wear, but decreases with spindle speed firstly and then increases with it within the cutting range tested. Thrust force caused by the copper foil is much larger than that caused by the epoxy glass fiber cloth when feed rate is low. However, the difference between them decreases as feed rate increases. The thickness of nail head increases with thrust force. The accuracy of hole location increases with thrust force firstly but decreases afterward. The influence of thrust force on hole wall roughness is not obvious.