Papers by Author: Chong Gao Zhang

Abstract: The high-speed hard and dry cutting chips of hardened alloy-steel with PCBN tool is presented in this paper: After the work piece temperature measured by ThermaVision infrared thermometer, it is proved that the heat generated by cutting is carried out by chips; After SEM analyzed chip it is proved that the cutting temperature is increased and then fallen and the PCBN tool suitable for high-speed hard and dry cutting. It is suitable for PCBN tool cutting hardened alloy-steel 42CrMo instead of grinding.

Abstract: This paper deals with the High-speed Hard and Dry Cutting mechanism of hardened alloy-steel with PCBN tool: the cutting speed and workpieces temperature and tool wear are being discussed in different cutting speeds when cutting alloy-steel 42CrMo. After the workpiece temperature measured by ThermaVision, it is proved that the workpiece temperature was not high and changed little. Through the SEM and EDS analyses for chip and tool wear, it is proved that PCBN tool is suitable for High-speed Hard and Dry Cutting. It is suitable for PCBN tool to cut hardened alloy-steel 42CrMo instead of grinding.

Abstract: The two cutting tools obtained from ultra-fine grade Ti (C,N)-based cermets were tested in the dry cutting of a medium carbon steel (AISI1045). Microstructure and mechanical properties were studied. Wear mechanisms (mainly diffusion and oxidation) were investigated in detail and compared each other in order to better understand key aspects due to thermal wear mechanisms. Comparing tool A with B, under the adopted cutting conditions, the tool A has a better resistance to oxidation deformation in machining medium carbon steel due to the higher hardness, although tool B has higher bending strength and fracture toughness.