Papers by Author: Daniel Lallement

Abstract: The manufacturing of aeronautic parts with high mechanical properties requires the use of high performance materials. That’s why; new materials are used for landing gears such as the titanium alloy Ti-5553. The machining of this material leads to high cutting forces and temperatures, and poor machinability which requires the use of low cutting conditions. In order to increase the productivity rate, one solution could be to raise the workpiece initial temperature. Assisted hot machining consists in heating the workpiece material before the material removal takes place, in order to weaken the material mechanical properties, and thus reducing at least the cutting forces. First, a bibliography review has been done in order to determine all heating instruments used and the thermal alleviation that exists on conventional materials. An induction assisted hot machining was chosen and a system capable to maintain a constant temperature into the workpiece during machining (turning) was designed. Trails permit to identify the variation of cutting forces according to the initial temperature of the workpiece, with fixed cutting conditions according to the TMP (Tool-Material-Pair) methodology at ambient temperature. Tool life and deterioration mode are identified notably. The results analysis shows a low reduction of specific cutting forces for a temperature area compatible with industrial process. The reduction is more important at elevated temperature. However, it has consequences on quality of the workpiece surface and tool wear.

Abstract: The aim of this paper is to study the machinability of a new titanium alloy: Ti-5AL-5Mo-5V-3CR used for the production of new landing gear. First, the physical and mechanical properties of this material will be presented. Second, we show the relationship between material properties and machinability. Third, the Ti5553 will be compared to Ti64. Unless Ti64 is α+β alloy group and Ti5553 is a metastable, we have chosen to compare these two materials. Ti64 is the most popular of titanium alloys and many works were been made on its machining. After, we have cited the Ti5553 properties and detailed the behavior laws. They are used in different ways: with or without thermal softening effect or without dynamic terms. The goal of the paper is to define the best cutting force model. So, different models are compared for two materials (steel and titanium alloy). To define the model, two methods exist that we have compared. The first is based on machining test; however the second is based on Hopkinson bar test. These methods allow us to obtain different ranges of strain rate, strain and temperature. This comparison will show the importance of a good range of strain rate, strain and temperature for behavior law, especially in titanium machining.