Papers by Author: Egor Prokofiev

Abstract: The article represents results of influence of different severe plastic deformation (SPD) techniques on TiNi alloys. It is demonstrated that strength and shape memory effect (SME) of TiNi can be significantly enhanced due to formation of ultrafine-grained (UFG) and nanocrystalline (NC) structures by SPD. Influence of equal channel angular pressing (ECAP), high pressure torsion (HPT), multi-step SPD deformations (ECAP plus cold rolling) on structure, mechanical and functional properties of TiNi alloys is considered. There are represented first results of influence of equal channel angular pressure-Conform (ECAP-C) on TiNi alloys, which is a perspective technology for industrial fabrication of UFG metals and alloys.

Abstract: Severe plastic deformation (SPD) processes, are successfully employed to produce ultra fine grain (UFG) and nanocrystalline (NC) microstructures in Ni50.7Ti49.3 shape memory alloy. The effect of grain size on phase transformations during annealing is investigated by differential scanning calorimetry (DSC) and transmission electron microscopy (TEM). The results of comparative studies of phase transformations in coarse-grained, UFG and NC alloys after SPD and subsequent long-term (up to 100 hours) annealing at 400С is presented. The functional properties and the innovation potential of UFG NiTi alloys is considered and discussed.

Abstract: Martensitic transformations in NiTi shape memory alloys (SMAs) strongly depend on the microstructure. In the present work, we investigate how martensitic transformations are affected by various types of ultra-fine grained (UFG) microstructures resulting from various processing routes. NiTi SMAs with UFG microstructures were obtained by equal channel angular pressing, high pressure torsion, wire drawing and subsequent annealing treatments. The resulting material states were characterized by transmission electron microscopy and differential scanning calorimetry (DSC). The three thermomechanical processing routes yield microstructures which significantly differ in terms of grain size and related DSC chart features. While the initial coarse grained material shows a well defined one-step martensitic transformation on cooling, two-step transformations were found for all UFG material states. The functional stability of the various UFG microstructures was evaluated by thermal cycling. It was found that UFG NiTi alloys show a significantly higher stability. In the present work, we also provide preliminary results on the effect of grain size on the undercooling required to transform the material into B19’ and on the related heat of transformation.

Abstract: Amorphous-nanocrystalline Ti49.4Ni50.6 alloy in the shape of a disc 20 mm in diameter has been successfully produced using high pressure torsion (HPT). Application of HPT and annealing at temperatures of 300–550°C resulted in formation of a nanocrystalline (NC) structure with the grain size (D) about 20–300 nm. The HPT samples after annealing at Т = 400°C with the D= 20 nm possess high yield stress and high ultimate tensile strength (more than 2000 MPa). There is an area of strain-induced transformation B2-B19’ on the tensile curve of the samples with the grain size D =20 nm. The stress of martensitic transformation (σm) of samples is 450 MPa, which is three times higher than σm in the initial coarse-grained state (σm ≈ 160 MPa). The HPT samples after annealing at Т = 550°C with the D= 300 nm possess high ductility (δ>60 %) and high ultimate tensile strength (about 1000 MPa).