Papers by Author: F. Tarlochan

Abstract: The strength of a green compacts formed through warm powder compaction route is strongly dependent on the forming load and temperature. As the forming load increases, the powder particles move from its initial position by sliding among them and die wall. This movement results in new arrangement and packing order of the particles. However, due to this movement, pores among the particles are generated that affects the mechanical properties of the green compacts. Having pores in green compacts lead to strain intensification at ligaments between pores during sintering at later stage, hence serve as areas for crack initiation. Therefore, as the powder forming relates directly to the load and temperature, strength to porosity relationship has to be analyzed based on those parameters. This paper presents the effect of porosity to the strength of green compacts formed at different load and temperature (70 kN to 130 kN; 30°C to 200°C). The bending strengths of green compacts are measured while Scanning Electron Microscopy is used for porosity evaluation. It has been found from the results that porosity and strength are related to each other at all forming parameters. In addition, high forming load and temperature give better strength due to porosity reduction.

Abstract: Powder compaction at elevated temperature or known as warm compaction is a process of producing green compacts from metal powder, which is generally conducted between the ambient and the recrystalization temperature of the main powder constituent. Even though, warm compaction was initiated at around 1998, not a lot of information can be found in the literature especially on the numerical simulation of the process. Therefore, this paper presents the simulation of warm metal powder forming process by using the developed computer code. The Elliptical Cap yield model has been used to represent the deformation behaviour of the powder mass during the forming process at above ambient temperature. The material properties of powder mass, i. e., friction coefficient, elastic index, and plastic index, at different forming temperature, are established through warm compaction experiment. The simulation was conducted to generate a green compact of a plain bush component. Some numerical simulation results were validated through experimentation, where a good agreement was found between the numerical simulation and the experimental results.