HOME CONTACT My eBook

Username: Password:

> @scientific.net

Articles by author: Gang Liu

• A FEM Study on Chip Formation in Orthogonal Turning Nickel-Based Superalloy GH80A
  Published in: Physical and Numerical Simulation of Materials Processing (p1370)
• An Investigation of the Wear Mechanism for Carbide Tools in Face Milling the Ti-5Al-4.75Mo-4.75V-1Cr-1Fe Alloy
  Published in: Machining and Advanced Manufacturing Technology X (p547)
• Cutting Parameters Optimization by Fuzzy Synthetic Evaluation and BP Neural Network in Milling Aluminum Alloy
  Published in: Machining and Advanced Manufacturing Technology X (p543)
• Determining Structural Modes of HSK Tool System Based on FEM and EMA
  Published in: Manufacturing Engineering and Automation I (p1479)
• Development of Whole Life Cycle Management System on Cutting Tool
  Published in: Manufacturing Science and Materials Engineering (p666)
• Dry Turning of Rotor Steel 26NiCrMoV145 Using Multilayer Coated Cemented Carbide Tools
  Published in: Advances in Materials Processing IX (p250)
• Experimental Study on Cutting Characteristics for Buttress Thread Turning of 13%Cr Stainless Steel
  Published in: Advances in Materials Processing IX (p262)
• Experimental Study on the Performance of WC-Co Inserts in Turning 4Cr13 Die Steel
  Published in: Advances in Materials Processing IX (p256)
• Optimization of Surface Roughness by Uniform Design of Experiments in Milling of 1Cr18Ni9Ti
  Published in: Ultra-Precision Machining Technologies (p490)
• Researches on Burr Formation in Milling Al-Alloy
  Published in: Surface Finishing Technology and Surface Engineering II (p164)
• Resin Bonded CBN Grinding Wheel Dressing by Laser — Simulation and Experiment
  Published in: Advances in Grinding and Abrasive Technology XIII (p38)
• Study on Grinding Technology of Electrical Discharge Grinding of Curve Edge Polycrystalline Diamond
  Published in: Advances in Grinding and Abrasive Technology XIII (p206)
• Study on the Cutting Force, Temperature and Residual Stress in Milling the New Rotor Steel
  Published in: Advances in Abrasive Technology XIII (p923)
• Study on the Machinability of Two Different Sulfur Free Cutting Steels
  Published in: Ultra-Precision Machining Technologies (p510)
• Study on Whole Life Cycle Management of Cutting Tool
  Published in: Future Material Research and Industry Application (p234)