Papers by Author: Hui Li

Abstract: Carbon nanotube used as the cathode material, the diode-type field emission display panel was developed with low-cost screen-printing method and precise photolithography process. The modified CNT field emitter was fabricated for improving the field emission characteristic, and the detailed fabrication process was also presented. The indium-tin-oxide film on the cathode back-plane was divided to form the CNT cathode electrode, and the insulation slurry was screen-printed to form the insulation layer. Field emission characteristic of whole display device was measured. The sealed field emission display panel showed good emission properties and high display image brightness.

Abstract: In this paper, TiN coating was deposited onto the nitrided 32Cr2MoVA by multi arc ion plating and proceeded line contact fatigue experiment to investigate the influence of hard coatings on the contact failure properties of nitriding steel. The results of experiment show that pitting is primary type of contact fatigue failure for TiN coated 32Cr2MoV and the pits on the TiN coated surface are shallower and smaller than that of the nitrided 32Cr2MoV. After TiN coating produce crisping and desquamation under higher contact fatigue loads, the exposed matrix surface begin to bear the contact load. The superficial microstructure of TiN coated 32Cr2MoV was more fine, and content of nitrides were higher than that of the nitrided, which insured the distribution of hardness gradient of subsurface was more rational than that of nitrided 32Cr2MoV. The contact fatigue strength of TiN coated 32Cr2MoV is greater about 200MPa than that of the nitrided 32Cr2MoV.