Papers by Author: J. Neil Merrett

Abstract: Trenched, vertical SiC static induction transistors (SIT) for L-band power amplification were fabricated with implanted p-n junction gates on conducting n-type 4H-SiC substrates using a self-aligned fabrication process. The self-aligned fabrication process required no critical alignments and allowed for high channel packing densities ranging from 2.9x103 to 5x103 cm/cm2. Devices were fabricated with a range of finger widths. Devices with the narrowest fingers were able to block up to 450 V with VGS = -3 V. Devices with wider fingers required higher gate voltages ranging from -10 V to -25 V to achieve similar blocking. Devices were packaged and small-signal and loadpull measurements were taken with the devices externally matched. Devices having the narrowest finger design had a small-signal power gain of over 9 dB at around 1.3 GHz. Load-pull measurements of packaged SITs with 1 cm gate periphery yielded a maximum power gain of ~ 8.2 dB at 1 GHz, VDD = 100 V, and VGS = 1.2 V. Due to the high packing density, these results translate to power densities of 22 kW/cm2.

Abstract: In this work we have demonstrated the operation of 600-V class 4H-SiC vertical-channel junction field-effect transistors (VJFETs) with 6.6-ns rise time, 7.6-ns fall time, 4.8-ns turn-on and 5.4-ns turn-off delay time at 2.5 A drain current (IDS), which corresponds to a maximum switching frequency of 41 MHz – the fastest ever reported switching of SiC JFETs to our knowledge. At IDS of 12 A, a 19.1 MHz maximum switching frequency has been also achieved. Specific on-resistance (Rsp-on) in the linear region is 2.5 m
·cm2 at VGS of 3 V. The drain current density is greater than 1410 A/cm2 at 9 V drain voltage. High-temperature operation of the 4H-SiC VJFETs has also been investigated at temperatures from 25 °C to 225 °C. Changes in the on-resistance with temperature are in the range of 0.90~1.33%/°C at zero gate bias and IDS of 50 mA. The threshold voltage becomes more negative with a negative shift of 0.096~0.105%/°C with increasing temperature.

Abstract: 4H-SiC vertical depletion-mode trench JFETs were fabricated, packaged, and then irradiated with either 6.8 Mrad gamma from a 60Co source, a 9x1011 cm-2 dose of 4 MeV protons, or a 5x1013 cm-2 dose of 63 MeV protons. 4H-SiC Schottky diodes were also fabricated, packaged and exposed to the same irradiations. The trench VJFETs have a nominal blocking voltage of 600 V and a forward current rating of 2 A prior to irradiation. On-state and blocking I-V characteristics were measured after irradiation and compared to the pre-irradiation performance. Devices irradiated with 4 MeV proton and gamma radiation showed a slight increase in on resistance and a decrease in leakage current in blocking mode. Devices irradiated with 63 MeV protons, however, showed a dramatic decrease in forward current. DLTS measurements were performed, and the results of these measurements will be discussed as well.