Papers by Author: Jean Philippe Chateau

Abstract: The combination of high temperature (1050°C -1150°C) testing and in situ high energy X-Ray diffraction measurements using synchrotron Three Crystal Diffractometry may give various insights into the mechanical behaviour of superalloys: measurement of the lattice mismatch, order within the ' phase, elastic constants, and dynamic response to changes in the experimental conditions. Several examples are given on the rafted AM1 superalloy, resulting from experiments at the ID15A (ESRF) and BW5 (DESY) high energy beamlines.

Abstract: One of the major ingredients of modelling the mechanical behaviour of superalloys is the knowledge of dislocation densities and strain distribution. Both can be measured using post mortem BF TEM and CBED, but such methods do not allow following their variations during a test. The aim of the present work is to investigate the usefulness of in situ X-Ray Three Crystal Diffractometry (TCD) to measure the density and distribution of dislocations within a rafted superalloy, i.e. during stage II of high temperature creep. As the instrument contribution is very low, the two-peaked experimental profiles are representative of the lattice parameter distribution within the material. The profiles were measured within bulk specimens at the BW5 high energy beamline Hasylab (DESY), during high temperature (1050°C to 1180°C) tests under loads between 0 MPa and 300 MPa. The peak shapes were observed to change with varying experimental conditions. The peak width follows different patterns under low and high stress, i.e. with low and high strain rates. The distribution of elastic strains was calculated by assuming two main contributions: dislocation segments trapped at the γ/γ’ interfaces in a more or less regular network, and dislocations moving within the γ’ rafts. A comparison between experimental and simulated peaks shows that several features of their behaviour can be explained: the absolute magnitude of the peak width, the observed decrease of the peak width under low loads with increasing interfacial dislocation densities. The larger increase in the width of the γ’ peak under high load (and strain rate) may be attributed to a dislocation density within the 1013 m-2 range within the rafts. The present results are presently being cross-checked by post mortem TEM observations.

Abstract: We elaborated two carbide-free bainitic steels with different microstructures through specific heat treatments and alloy design. EBSD analysis was used to point out major differences in these microstructures. In-situ characterizations of the bainitic transformation were performed by high energy synchrotron diffraction to go further into the study of each phase characteristics. The elaborated microstructures exhibited various phase fractions of bainitic ferrite, retained austenite and blocks of martensite and retained austenite. Moreover, the volume fraction of retained austenite increased with higher austempering temperatures. On the other hand, the austempering temperatures showed a strong influence on the kinetics of the bainitic transformation. Isothermal transformation under Ms showed a two stage transformation which led first to the formation of self-tempered martensite and then to bainitic ferrite. Furthermore, the evolution of the austenitic cell parameter showed enrichment in carbon ruled by diffusional mechanisms.