Papers by Author: Jiin Yuh Jang

Abstract: This study presents heat transfer rate and temperature distributions for the prediction of each component in an air-cooled motorcycle engines. The 3-D finite element method was used to solve the temperature field and heat transfer rate for each component (intake valves, exhaust valves, piston, piston rings, cylinder head and cylinder) of motorcycle engine when the piston is in TDC and BDC. The results shows that the fractions of heat transfer rate for each component are as follows: intake valves 11％, exhaust valves 8％, cylinder head 21％, the piston 35％ and the cylinder 25％. And the temperature measurement value is in good agreement with experimental data within 20%.

Abstract: In order to inspect on wall condition inside the coke oven, an inspection device has been developed to protect a camera inside and sustains high temperature long enough so that it can be permanently-installed on the pusher ram beam. The temperature of the coking chamber during operation is about 1200 °C while the maximum tolerable temperature of a camera is less than 40 °C. The device has to function as a good thermal insulator with cooling element for the camera at the pusher head and for signal cables along the beam. In this paper, the necessary conditions of the inspective device were found out by building a three-dimensional numerical model of the device to simulate the temperature distribution inside the device with CFD commercial software.