HOME CONTACT My eBook

Username: Password:

> @scientific.net

Articles by author: José Valdemar Fernandes

• A Numerical Study on the Mechanical Behaviour of Hard Coatings with Ductile Interlayers under Depth-Sensing Indentation
  Published in: Advanced Materials Forum V (p1194)
• Characterisation of Modified Sputtered (TiAl)-Based Intermetallic Materials Doped with Silver and Chromium
  Published in: Development in Light Metals (p37)
• Cyclic Deformation Behaviour of Copper Polycrystals Pre-Strained in Tension
  Published in: Advanced Materials Forum II (p330)
• Dislocation Microstructure in Copper Multicrystals Deformed under the Sequences: Rolling - Tension and Tension - Rolling
  Published in: Advanced Materials Forum III (p589)
• Influence of Plastic Deformation of the Heat Affected Zone on the Mechanical Behaviour of Welds in High Strength Steels
  Published in: Engineering Plasticity from Macroscale to Nanoscale (p791)
• Influence of the Mechanical Microtwinning on the Plastic Behaviour of the AISI 304 Stainless Steel
  Published in: Advanced Materials Forum II (p711)
• Microstructural Plastic Behaviour of AISI 304 Austenitic Stainless Steel
  Published in: Advanced Materials Forum II (p280)
• Numerical Simulation of Ultramicrohardness Tests in Thin Films
  Published in: Advanced Materials Forum II (p694)
• Numerical Study of the Influence of Imperfection of the Tip of a Vickers Indenter on Ultramicrohardness Test Results
  Published in: Advanced Materials Forum I (p525)
• Plastic Behaviour of Copper Polycrystal Subjected to Fatigue-Tension Sequential Loading Tests
  Published in: Advanced Materials Forum III (p897)
• Strain and Stress Distribution in Vickers Indentation of Coated Materials
  Published in: Advanced Materials Forum III (p1472)
• Strain Path Change Effect on Deformation Behaviour of Materials with Low-to-Moderate Stacking Fault Energy
  Published in: Advanced Materials Forum IV (p420)
• Taylor Analysis for {111}<112> Twinning on One System and {111}<110> Slip Under Tension and Compression Flow Conditions
  Published in: Advanced Materials Forum I (p509)