Papers by Author: Józef Rasek

Abstract: In the paper Fe82Nb2B16, Fe80Nb2B18 and Fe78Nb2B20 amorphous alloys, obtained by melt spinning, were examined. It was shown that the alloys studied in the as quenched state and in the relaxed amorphous state or in nanocrystalline state (after a suitable annealing) belong to very good soft magnetic materials with relatively high resistivity. The influence of annealing on brittleness as well as magnetic and electric properties measured at room temperature was examined. A correlation between sample microstructure (in the as quenched state and after annealing) and different physical properties is discussed. It was shown that the observed changes of relative magnetic permeability can be explained by changes of magnetoelastic energy, concentration of microvoids frozen during production process, effective anisotropy constant and magnetic polarisation.

Abstract: The aim of the present paper is to find correlations between structural changes and electrical, mechanical and magnetic properties in Fe78Si13B9, Fe76Nb2Si13B9, Fe75Cu1Nb2Si13B9, Fe75Cu1Zr1Co1Si13B9, amorphous and nanocrystalline alloys obtained by melt spinning technique. The influence of annealing on material brittleness, magnetic and electric properties was examined. It was found that the optimization of soft magnetic properties effect is a thermally activated process and its diffusion parameters were determined. It was shown that for the alloys containing Cu, Nb and Zr as alloying additions, the optimization process can be attributed to formation of a nanocrystalline phase. In contrast to this for the FeSiB and FeNbSiB alloys the optimization process should be related to the relaxed amorphous phase.

Abstract: In the present work X-ray studies were performed on annealed Fe78Nb2B20 amorphous alloy prepared by melt-spinning technique. All the samples were annealed in vacuum for 1 hour at temperatures up to 800°C. For the studied alloy -Fe and Fe2B are the stable, crystalline phases. The -Fe crystallized as the first crystalline phase in the sample annealed at 350°C. On the other hand, metastable Fe3B phase appeared to be stable during annealing in 425-800°C temperature range. The best fitting of the experimental X-ray data to as jet available ICDD files was obtained for Ni3P type structure (39-1315 – S.G.: I (82)). New, experimental powder diffraction data for metastable Fe3B phase prepared according to ICDD standards were elaborated for the sample annealed at 600°C. For this sample the best agreement between the calculated values of lattice constants and positions of experimental diffraction lines was obtained. The X-ray data were collected using X-Pert Philips diffractometer equipped with curved graphite monochromator on diffracted beam. The Treor program was applied for the analysis of X-ray diffraction data.

Abstract: The crystallization and optimization of magnetic properties effects in FeXSiB (X=Cu, V, Co, Zr, Nb) amorphous alloys were studied by applying X-ray diffraction methods, high resolution transmission electron microscopy (HRTEM), resistometric and magnetic measurements. The temperatures of the first and the second stage of crystallization, the 1h optimization annealing temperature and the Curie temperature were determined for different amorphous alloys. Activation energies of crystallization process were obtained by applying the Kissinger method. The influence of alloy additions on optimization effect and crystallization processes was carefully examined.