Papers by Author: Juliana Gutiérrez

Abstract: In this work a kinetic model which describes the main refining reactions in a ladle furnace is depicted. The main difference between this work and other models previously reported relies on a formal quantification of the multi-component diffusion kinetics expressed as an analytical solution. Results from this model reproduce/predict adequately the chemical steps involved in an integrated steel shop.

Abstract: This paper discusses the effect of the main parameters that affect the desulphurization reaction efficiency. The study was conducted by evaluating different reaction sites within the metal, the slag and the reducing agents. It was possible to establish a mass transfer model that determines the amounts of the reducing agents needed to maintain adequate sulphur levels in the pig iron. Industrial trials showed the accuracy of our model.

Abstract: A three dimensional numerical heat transfer model has been developed to estimate the heat flux trough furnace side walls protected with water cooled cooling fingers. The model was set up by means of the finite element method. Materials with different thermal conductivity were modelled and the results obtained with the mathematical model were compared with experimental data. In every case, it was found excellent agreement between the experimental data and the model computations.

Abstract: In this paper we propose the design of a novel induction furnace for glass melting. The design is based on a mathematical analysis and performed numerically by means of the Finite Element Method. Several induction coils configurations were tested. The results from the mathematical model show that it is possible to melt glass in a furnace whose hearth is no larger than half a metre by using axial induction coils and high frequencies. This furnace configuration may result in increased glass melting rates along with the elimination of harmful emissions.

Abstract: The rate of reduction of chromium oxides in a stainless steel slag was studied in stagnant slag / metal melts at 1600 °C. The experimental results show that the magnesium contained in a FeMgSi ferroalloy has a reduction potential comparable to that of the silicon in a FeSi ferroalloy. On the other hand, it was confirmed that the rate limiting step in the reduction of the chromium oxides is the transport of chromium from the bulk of the slag to the slag / metal interface. The mass transfer coefficients for the reduction of chromium were estimated and are in good agreement with previously reported values.

Abstract: Several analytical models have been developed through the years to describe the formation and growth of the internal oxidation layer in binary alloys. Such models are often complex and their validity strongly rely on precise measurements of molar fluxes of the different species involved in the oxidation process. The main disadvantage of such measurements is that they are difficult to made and present a high degree of uncertainties, thus some assumptions are needed to ease understanding and the applicability of them. In this paper we set up a numerical scheme (finite differences) to describe the growth of the internal oxidation layer in binary Cu-Al alloys oxidized in air at different temperatures. There is good agreement between the experimental results and the values calculated with the aid of our numerical approach.