Papers by Author: Ki Seok Hong

Abstract: Two different types of carbon fibre bundles were used for filament winding to obtain C/C preforms. C/C-SiC composites were produced from the C/C preforms by a silicon melt infiltration technique. The effect of the type of carbon fibre bundle on the mechanical and thermal properties of the resultant C/C-SiC composites was compared. The spun fiber preform yields C/C-SiC composites of better mechanical properties than the unidirectional continuous fiber preform. The strength of the composites from the SFP was 1.8 times higher than that from the CFP. The flexural strength and the O-ring strength of the composites from the SFP with a density of 2.35 g/cm3 were about 160 MPa and 170 MPa, respectively.

Abstract: The Ministry of Commerce, Industry and Energy has contracted with the KIER including the ceramics company to localize of the ceramic heat exchanger tubes and its components. The basic objective of this paper is to develop a ceramic formulation and process which would yield a cost-effective and long-life Si/SiC tube materials by extrusion and reaction sintering process. Thus,KIER is currently developed and localized heat exchanger tubes with 40mm out diameter, 1500mm length. This paper was tested the mechanical and thermal properties of the localized Si/SiC tubes obtained from reaction sintering. Also, the effect of energy savings of the heat exchanger after exposure to forging furnace with hot corrosive environment was investigated.