Papers by Author: Lin Wang

Abstract: A perfect spam filter would avoid ham misclassification. This paper describes the development and application of spam filter. Specifically, the evaluation methodology was designed on-line open source spam filters. Finally, ASP-based anti-spam management system was created to combine the results of multiple filters. We finally find that the filters of ASP-based anti-spam system also make mistakes but can be used in conjunction with users to minimize errors.

Abstract: The microstrctural evolution pre and post heat treatment is critical to achieve a successful product for metal forming process. This paper aims to investigate the microstructual effect of the magnesium alloy tubes undergone various heat treatment conditions to achieve material homogenization. The heat treatment conditions under various periods of time (1, 2, 6, 12 and 30 hours) at 400 °C were employed to investigate the microstructural effect on hydroforming magnesium tubes. The greatly reduced impurity embedded in grain boundaries and more uniform grain sizes do indicate the improvement of material strength and ductility. To validate the conclusion, corresponding tensile tests at the different temperatures (20 °C and 200 °C) were carried out. The increased engineering strain in two directions (hoop and longitudinal) implies that the microstructural evolution is unquestionably useful to enhance the ductility of the magnesium tubes. Subsequently, the tubes after optimal heat treatment condition at 400 °C for 6 hours were used to further carry out the thermal hydroforming process for validation. The defect-free hydroformed tubes were produced under the same working condition, which is unable to be achieved for tubes without the heat-treatment process.

Abstract: In this paper, the effect of strain rate has been considered in the simulation of forming process with a simple form combined into the material law. Quite a few researchers have proposed various hardening laws and strain rate functions to describe the material tensile curve. In this study, the strain rate model Cowper-Symonds is used with anisotropic elasto-plastic material law in the simulation process. The strain path evolution of certain elements, when the strain rate is considered and not, is compared. Two sheet materials, Cold-reduced Carbon Steel (SPCC) JIS G3141 and Aluminum alloy 6112 are used in this study. Two yield criteria, Hill 48 and Hill 90, are applied respectively to improve the accuracy of simulation result. They show different performance when strain rate effect is considered. Strain path of the elements in the fracture risk area of SPCC (JIS G3141) varies much when the strain rate material law is used. There is only little difference of the strain distribution of Al 6112 when the strain rate effect is included and excluded in the material law. The simulation results of material SPCC under two conditions indicate that the strain rate should be considered if the material is the rate-sensitive material, which provides more accurate simulation results.