Papers by Author: M. Sivakumar

Abstract: Laser treatment is a promising technique for dental applications such as caries prevention, dental hypersensitivity reduction and improvement of bond strength of restoration materials. In this study the morphological, structural and chemical changes of enamel surface due to treatment with KrF excimer laser radiation were evaluated using scanning electron microscopy, X-ray diffraction, and X-ray photoelectron spectroscopy. For radiation fluences near 1 J/cm², laser processing originates a relatively porous surface due to preferential removal of material in the enamel prism sheaths. Increasing the fluence leads to a relatively flat surface with clear evidence of surface melting. The X-ray diffractograms of both treated and untreated enamel are similar and correspond to hydroxyapatite. The only modification due to the laser treatment is a slight shift of the peaks, probably, due to a loss of the structural water of hydroxyapatite. X-ray photoelectron spectroscopy confirmed that organic matter is removed from the irradiated surface but no significant changes in the mineral phase occur.

Abstract: In the present paper, the influence of tubule orientation and areal density on the development of surface textures by excimer laser processing of dentin is analysed. Disks of dentin 2 mm thick were extracted from caries-free human teeth by cross-sectional cutting above the pulp cavity, polished and fixed using standard procedures. The samples were laser-processed using 100 laser pulses of 248 nm wavelength radiation at a fluence of 1 J/cm2, pulse duration of 30 ns and pulse frequency of 5 Hz. The surface texture after processing depends on the angle between the tubules and the laser beam. In inner dentin, where tubules are parallel to the laser beam, cone-like artefacts form, considerably increasing surface roughness. The cones are constituted by partially melted peritubular dentin and develop because the ablation rate of peritubular dentin is lower than the ablation rate of surrounding intertubular dentin. The areal density of cones is roughly identical to the areal density of tubules except when the tubule density is high enough to allow adjacent cones to coalesce. In outer dentin, where tubules are tilted with respect to the laser beam, the surface remains flat. The reason for this orientation dependence is that, when tubules are tilted towards the laser beam, preferential removal of intertubular dentin will expose an increased area of underlying peritubular dentin to laser radiation preventing cone development.

Abstract: In the present work, dentin samples extracted from human molar teeth were treated with 248 nm wavelength pulsed laser radiation at fluences between 0.5 and 20 J/cm2. The surfaces were characterised by scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FTIR) and x-photoelectron spectroscopy (XPS). Two distinct behaviours were observed in what concerns the evolution of surface morphology with fluence and number of pulses. In some samples the surface remained flat, independently of the fluence and covered by a layer of resolidified material and redeposited ablation particles, which often occluded the dentinal structure. In other samples the surface topography depended on radiation fluence. For fluences below 1 J/cm2, intertubular dentin was preferentially removed, originating a columnar structure where columns were centred on the dentinal tubules and constituted by peritubular dentin. The height of the columns increased with the number of laser pulses. When fluence exceeded 1 J/cm2 the processed surface remained flat, covered with a fine resolidified layer. These distinct behaviours of dentin can be explained by differences in the constitution of this composite biological material. Despite the topographic changes observed, the mineral phase of dentin (apatite) remained unaltered and collagen was removed only from the outermost superficial layers of the processed material. This fact is explained by the constitution and structure of dentin and by the physical properties and electronic structure of its main constituents. Taking into consideration the results obtained and the bond type and properties of the constituents of dentin, it is suggested that the ablation of collagen occurs by a photochemical mechanism while the ablation of apatite is photothermal.