Papers by Author: Ming Jun Feng

Abstract: The mechanical properties of flat end mill is analyzed the high-speed milling, the linear model for milling force is established. And the 2A70 aluminum alloy four-factor four-level orthogonal milling tests are carried out, the nonlinear model of milling is set up by using regression analysis method. The comparative analysis is made between the linear model and nonlinear model, whose results show that the two models have good agreement on the value and trend of change, which is the basis of the follow-up tool path optimization, fault diagnosis and so on.

Abstract: According to the condition of the high speed milling aluminum (al) blades, the wear characteristics of the carbide tool was observed, whose wear characteristics mainly were flank wear, micro-tipping, exfoliation and so on. With the increase of the cutting time, the tool wear became larger according to the increment of the spindle speed. At the condition of the same feed per tooth, applying high speed finish milling for al alloy blades whose cutting efficiency increased remarkably, surface roughness decreased, high speed machining was adopted in real applications to achieve high economical benefits.

Abstract: A data fusion algorithm was established for estimating the state of target tracking system with multi-type sensor. Through Kalman filter regarding the multi-sensors to computer goal estimated value, it can obtain estimation value of goal at moment. And mean square deviation of fusion estimation value was smaller than single sensor's mean square deviation. The simulation results indicated that synchronisms data fusion method was effective to the multi-target tracking problem. Asynchronous multi-sensor fusion process can obtain good control effect in the practice control process.

Abstract: According to the characteristics and cutting requirements of the compressor impeller, such as low rigidity, easy to produce deformation and vibration in machining process, the high speed machining technology was adopted to reduce time, the virtual manufacturing technology was used to solve processing problems in computer before the trial machining and improved programming speed and other key supporting technologies were adopted. The study shows that this green processing of impeller had high machining efficiency, good surface roughness and product quality, low production cost and light environmental pollution. It accords with modern green machining development trend.

Abstract: For taking advantage of high speed machining(HSM) in complex curved surfaces as impeller, the virtual manufacturing technology is adopted before the real machining, which can eliminate tool collision interference phenomenon of the trial cutting, avoid complicated process of trial test , forecast machining results efficiently. The simulation tests were proceeded to the each impeller procedure NC program by using the VERICUT virtual manufacturing soft to modeling five-axis machine tool HSM600U, and the result compared with the real machining is identical with one other. So it is tested that applying this technology can forecast the machining process truly.