Papers by Author: S.J. Hong

Abstract: An attempt was made to assess the surface damage in the isothermally degraded FSX414 Co-based superalloy using ultrasonic Rayleigh surface wave. Microstructural analysis (amount of solute Cr near the surface) and measurement of ultrasonic velocity and attenuation were performed after isothermal degradation heat treatment at 1100°C for up to 4000 hours. Rayleigh wave velocity was observed to increase with aging time, which was attributed to the increased depletion of Cr near the surface. Strong frequency dependence of Rayleigh wave velocity was found in the specimens with surface depletion layer. Attenuation coefficient of Rayleigh wave increased with increasing aging time. Therefore, both attenuation and velocity of ultrasonic Rayleigh wave are suggested as potential nondestructive evaluation parameters for the characterization of the thermally aged FSX414 superalloy.

Abstract: It was attempted to assess nondestructively the degree of isothermal degradation of 2.25Cr-1Mo steel by using high frequency longitudinal ultrasonic wave. Microstructural parameter (mean size of carbides), mechanical property (Vickers hardness) and ultrasonic attenuation coefficient were measured for the 2.25Cr-1Mo steel isothermally degraded at 630°C for up to 4800 hours in order to find the correlation among these parameters. The ultrasonic attenuation coefficients at high frequencies (over 35MHz) were observed to increase rapidly in the initial 1000 hours of degradation time and then slowly thereafter, while the ones at low frequencies showed no noticeable increase. Ultrasonic attenuation at high frequencies increased as a function of mean size of carbides. Ultrasonic attenuation coefficient was found to have a linear correlation with the hardness, and suggested accordingly as a potential nondestructive evaluation parameter for assessing the mechanical strength reduction of the isothermally degraded 2.25Cr-1Mo steel.