Papers by Author: Shuai An

Paper TitlePage

Abstract: This experiment adapt orthogonal experimental method, producing the experimental study on the impact of the open mill mixing process technological parameters on the mixing quality, using the open mill intelligent mixing experimental platform which are designed and developed dependently and a variety of advanced experimental equipment. Finally, find the optimal technological parameters for the open mill mixing process, and are the roller spacing 0.6mm, the best roller speed 29r/min, the best roller speed ratio 1.25, the best mixing temperature50°C, the best mixing time 18.5min, respectively.
400
Abstract: Experimental research on the relationship between rubber open mill mixing process parameters of roller pitch, roller speed and roller speed ratio changes and mix quality. The results show that the process parameters changes in open mill mixing process have significant effects on mixing quality and efficiency. And get the best process parameters optimization in open mill mixing process: the best changes trend of roller pitch, roller speed and roller speed ratio are from small to big, from small to big and from big to small.
223
Abstract: Rotor speed is one of the most important technical characteristics of the internal mixer. The effects of rotor speed on mixing process have been studied. In the experiments, three types of synchronous rotors which were two-wing synchronous rotor, four-wing synchronous rotor and six-wing synchronous rotor were used. The experimental results indicated that there was a proper speed of different rotor structure for mixing process. And along with the increase of rotor speed, the maximum power, the unit consumption of energy and discharging temperature increase, while the physical and mechanical properties of mixed rubber got a better value.
243
Abstract: Response surface method was used to optimize the process parameters of bio-packaging materials, which is produced by twin-screw extruder, in order to get the best performance, increase production levels. In this article, we use the Design Expert software, Box-Behnken Design module, under the conduction that the mass fraction of starch, plant fiber, polyethylene were respectively 70%,10%,30%, and keep a plasticizer to 5%, We analysis and optimize the screw extrusion temperature, speed and filler content, The results showed that the optimum technology parameters for screw speed 101.81 r•min-1, extrusion temperature 118.24°Cand filler content is 5.0.
279
Showing 1 to 4 of 4 Paper Titles