Papers by Author: Sönke Vogelgesang

Abstract: The mechanical and fatigue properties of Cu - Al - Mn shape memory alloys with different phase fractions at room temperature were investigated. The specimens with different chemical compositions (Al: 8.9 - 12.5 wt. % and Mn: 3.3 - 9.3 wt. %) were tensile loaded with 10-3 s-1 tensile strain rate. Austenitic specimens have the highest tensile strength and fracture strain. Yield strength, tensile strength and elongation of martensitic alloys were lower compared with austenitic alloys. Fracture strain of martensitic alloys depend only little on the chemical composition. Specimens of martensitic, austenitic and three different multiple phase specimens were tested in the high cycle fatigue range at room temperature. The Woehler curves for multiple specimens depend on the phase fraction at testing temperatures. Different elements as Co, Ni, Fe and Si were alloyed to CuAl11.6Mn5. All decreased the ductility of the specimens, and their fatigue properties. Maxima could be detected in the strain amplitude dependence of damping for multiple phase specimen. These maximum are shifted to lower damping and to higher strains with increasing number of mechanical cycles, compared to the as cast condition for not cycled specimen. The strain amplitude dependence of damping in martensitic and austenitic Cu – Al – Mn shape memory alloys does not change much during mechanical cycling.

Abstract: The strain amplitude dependent internal friction at room temperature and the transition temperatures of CuAlMn-shape memory alloys with Al contents from 8.9 wt.% to 12.7 wt.% and Mn contents from 4.7 wt.% to 9.3 wt.% were investigated. The investigated strain range was 10-6 - 10-3. Rods of various compositions were die cast and machined to single clamped damping bars. Their transition temperatures and amplitude dependent damping was determined in as cast and homogenized state. The damping in the investigated shape memory alloys was found to be generally much higher than in metals without martensitic transition. In as cast state some alloys exceeded the damping of a Sonoston type alloy measured in comparison for strains higher than 3 x 10-5. The influence of grain size on damping was investigated by additional sand casting and the use of Boron for grain refinement. It was found that only the material with the biggest grains had a noticeable higher damping over the whole measured strain range. Homogenization heat treatment can still extremely increase the damping of CuAlMn alloys. After homogenization this extremely high damping decreases slowly to medium values in the order of as cast alloys.