Papers by Author: Wei Juan Li

Abstract: With low-k dielectric materials taking the place of oxide dielectrics as the primary dielectric materials, the low-k dielectric materials and interconnection Cu metals during Chemical Mechanical Planarization (CMP) is becoming a critical surface quality issue as well. In this study, experiments are carefully designed and conducted to investigate the effects of colloidal silica under compared acidic slurry and self-prepared alkaline slurry on k value of low-k dielectric materials, and in both of the slurry, colloidal silica (20~30nm) was used as polishing abrasive. The results showed that k value of low-k dielectric materials both increased within a similar range (self-prepared alkaline slurry, 3.27~3.33; commercial acidic slurry, 3.26~3.32), however, the results showed a obviously different result from reference’s report.

Abstract: With the microelectronic technology node moves down to 45 nm and beyond, and to reduce the RC delay time, low-k dielectric materials have been used to replace regular dielectric materials. Therefore, the down force of chemical mechanical planarization (CMP) needs to decrease based on the characteristics of low-k materials: low mechanical strength. In this study, the effect of new complex agent on copper dissolution in alkaline slurry for CMP was investigated. Based on the reaction mechanism analysis of Cu in alkaline slurry in CMP, the performance of Cu removal rate and surface roughness condition were discussed. It has been confirmed that Cu1 slurry demonstrates a relatively high removal rate with low down force. And also, by utilizing the Cu1 slurry, good result of Cu surface roughness were obtained.