Papers by Author: Youn Ho Jung

Abstract: In this study, the variation of spring characteristics with increasing temperature was examined and the effect of their variations on the wear behavior of a nuclear fuel rod in both room and high temperature (300°C) water conditions was evaluated. From the results of the load-displacement tests, the spring stiffness was remarkably varied with increasing temperature. The results of the wear tests indicated that the wear damages are decreased at high temperature water when compared with the room temperature result. These results indicated that the removal mechanisms of wear debris at high temperature water are dependent on not only the formation of the wear particle layer but also on the changed contact conditions such as the contact length or area due to the stiffness drops.

Abstract: Slipping characteristic on the contacts between the tubes and the supports is investigated to study the fretting wear of a vibratory tube. Tests were carried out to simulate the vibration of the fuel rods supported by the springs and dimples. A tube was forced to vibrate with 30Hz. The supporting condition was varied artificially: positive contact force or gap existence. During the tube vibration, amplitudes were measured continuously in the vicinity of the supports. Simple equations were derived to evaluate the slip displacement on the contacts. As a result, it was found that the supporting condition affected the vibration characteristic near the contacts. In the positive contact condition, the phase difference of the vibration signals at both sides of the contact was 180 degrees. It is altered in the gap condition and the higher frequency components than 30Hz appeared. The severer wear in the case of the gap existence is discussed with the evaluated slip distance per cycle.