Papers by Keyword: α Fiber

Abstract: Formability had been important property of metals which is attributed to the texture development during thermomechanical processing particularly during hot rolling and cold rolling. In the present paper, the high strength steels with different carbon and manganese composition have been hot rolled above and below of austenite recrystallization temperature and followed by fast cooling up to different coiling temperature to get hot bands with different texture and two phase microstructure consisting ferrite with pearlite, bainite and martensite. Subsequently, these hot bands were cold rolled with 80 percent under plain strain condition. The microstructure of cold rolled sheets samples were analyzed using scanning electron microscope and showed the cold rolled microstructure with strong pancaked of two phase which was carried from the hot rolling. Cold rolled texture in ferrite pearlite microstructure is completely replaced by new texture components from hot rolled condition without the effect of Tnr. Hot rolled texture was retained in ferrite-bainite and martensite microstructure with the effect of Tnr. Increase in alloy chemistry weakens the texture intensity in ferrite pearlite/bainite microstructure. Whereas increase in alloy chemistry strengthens the texture intensity in ferrite martensite microstructure.

Abstract: In extra-low carbon steels, the generation of specific nucleation sites in the deformed microstructure determines the formation of an optimum recrystallization texture. In particular, during the cold rolling of the steel sheets, transition bands are generated in order to accommodate the different deformation paths followed by the deformation bands (DB-s) within the grains. -fibre grains (ND-fibre grains) are, in general terms, more fragmented than -fibre grains (RD-fibre grains). Consequently, the higher orientation gradients and stored energy levels of the -fibre grains determine the ND-fibre annealing texture. Nevertheless, during recrystallization of the ELC steel, nucleation in different type of transition bands (TB-s) between α-fibre components has also been observed in the present work. From a previous crystallographic classification of transition bands done by the authors, the effect of the lattice curvature, either by gradual or sharp orientation gradients, is studied during early recrystallisation stages. Specifically, the crystallographic characteristics of recrystallized nuclei formed at transition bands generated between α-fibre components are analyzed using electron back-scatter diffraction (EBSD). This technique enables the orientation of deformation bands, the misorientation across them, the orientation of the new recrystallized grains and the misorientation of those grains with the adjacent matrix grains to be determined. Recrystallization of components different to α at the expense of α components has also been found.

Abstract: During annealing of cold rolled steel sheets, the evolution of the texture, to produce the characteristic texture of a recrystallised material, depends on a series of factors, including the starting deformation texture, composition and processing conditions. In the present work, electron backscattered diffraction (EBSD) techniques have been used to investigate the deformation substructures being developed by cold rolling into grains belonging to different texture components. The strain localisation, the deformation banding, the spread in orientation into grains with different orientations are some of the aspects that have been considered. Annealing cycles at different temperatures have also been carried out in order to promote recovery and initial stages of recrystallisation . The obtained substructures have been compared to the as-cold rolled ones. It has been observed that recovery induces the dislocation structures to arrange into subgrains. Associated to the ND fibre, a network of relatively high angle boundaries develop within the subgrain structure. The recrystallisation nuclei have been observed to evolve from such a network.