Papers by Keyword: Automatic Width Control

Abstract: This paper proposes an automatic control strategy of the strip width in cold rolling process. The prediction model for the exit strip width of each stand is established. In addition to the strip width variation of the incoming hot-rolled material between the measured and the pre-set values, the variations of the rolling force, tension, bending force and the roll shift amount of each stand are utilized to model and forecast the stand exit width deformation. Then, the model can be used to determine the compensation values of the different profile adjustment mechanism and the exit strip width can be controlled in high accuracy. In this way, the effect of the strip width variation of the incoming hot-rolled material and the fluctuation of the stand rolling process parameters on the exit strip width can be eliminated. Moreover, the feed-forward control of the strip width can reduce the incidence of abnormal situation, such as the strip breakage and off-tracking ,and improve the stability of the cold rolling process.

Abstract: The slab edge rolling has been widely used in the roughing stand of hot strip mill to control the width of the slab. However, the slab edge rolling and consequent horizontal rolling will cause a significant width change in the head part and tail part of the slab, which have to be trimmed before the finishing stands. The short stroke control (SSC) technology has been developed to overcome this problem. In this paper, the finite element method (FEM) has been used to simulate the unsteady edge rolling process. Three SSC control curves have been compared in order to obtain the best width control result. The optimized SSC control curve has been applied to the industrial rolling mill.