Papers by Keyword: Back-Up Ring

Abstract: Based on finite element analysis software ANSYS, the deformation and force condition of the rubber sealing o-ring pre and post with back-up ring under different oil pressure conditions was analyzed. The von mises stress distribution of the o-ring and the change of contact pressure between o-ring and sealing interface pre and post with back-up ring under different oil pressure conditions were discussed. The results show that, the maximum von mises stress of the o-ring is smaller and the maximum von mises stress of the sealing system concentrates on the left top and the right bottom of the back-up ring after using it; the o-ring will not be extruded into the gap of the groove because of the existence of back-up ring which prevents gap-bite and prolongs service life of the o-ring; the contact pressure between o-ring and sealing interface increased, thus the sealing reliability of the system increased.

Abstract: Considering the advantages of the fine-blanking process, the smooth-cut surface without further operation could be fabricated. However, one of the major problems of the fine-blanking is the occurrence of the die-roll formation. This problem is the main factor which affects the quality of the fine-blanked parts. In this study, to reduce the amount of die-roll formation, the application of back-up ring was proposed. The finite element method (FEM) was used to investigate the effects of back-up ring. In addition, the effects of bridge width were also investigated. The FEM simulation results illustrated that the mechanism of back-up ring and the effects of bridge width could be theoretically clarified base on the material flow analysis. The FEM simulation and experimental results showed the good agreement with each other. Therefore, the application of back-up ring could reduce the amount of die-roll formation on the fine-blanked parts. In this study, the amount of die-roll formation increased as the bridge width increase and it was constant at the bridge width of over 15 mm.