Papers by Keyword: Coincidence Site Lattice Boundary

Abstract: Grain boundary structures in the commercial purity aluminum (1100Al) highly deformed by the accumulative roll bonding (ARB) process was observed by using conventional transmission electron microscopy (CTEM) and high resolution transmission electron microscopy (HRTEM). In the low angle grain boundary with a tilt angle (2θ) of 2.1o consisted of the periodic dislocations array, the interval of those dislocations could be explained by the dislocation model for grain boundary. However, the dense dislocation region locally existed at the vicinity of the low angle boundary. On the other hand, we also observed the high angle grain boundary of which the common axis and 2θ was <110> and 125.9o, respectively. In this grain boundary, we could describe the boundary configuration in terms of the combination of the kite-shaped structure unit characterized by Σ11 coincidence boundary with the 2θ of 129.52o around <110> and the additional dislocations to compensate the difference of the actual and geometrically coincided one.

Abstract: A 12-Tesla magnetic field was applied during the transformation from austenite to ferrite and then pearlite in a medium plain carbon steel at two different cooling rates. Results show that when cooling is slow, the magnetic field shows an effect of promoting proeutectoid ferrite grains to grow along the field direction that results in an elongated grain microstructure. However, when cooling is fast, the magnetic field mainly shows an effect of reducing the amount of low angle misorientations and increasing the amount of CSL boundaries. In addition, the magnetic field exhibits a slight enhancement of the <001> texture component in the direction that is perpendicular to the field direction (TFD).

Abstract: High magnetic fields were applied to the austenite to proeutectoid transformation and tempering process in a 42CrMo steel. The thermodynamic and kinetic effects of the high magnetic field on the austenite decomposition show that it can obviously increase the amount of the product ferrite and accelerate the transformation by enhancing the Gibbs free energy difference between the parent and product phases. Moreover, the magnetic field can considerably lower the amount of low angle misorientations of ferrite in pearlite colonies and obviously increase the frequency of S3-29 coincidence boundaries, especially S3 boundaries, of the ferrite. But it has no obvious effect on crystallographic orientation distribution. When the field is applied to the high temperature tempering process, it can effectively prevent the directional growth of cementite along martensite plate boundaries and twin boundaries by increasing both the cementite/ferrite interfacial energy and the magnetostrictive strain energy. Finally, particle-like cementite is obtained. The magnetic field also obviously retards the formation and growth of the ‘distortion-free’ regions of the matrix.

Abstract: Optimum parameters in the thermomechanical treatment during grain boundary engineering (GBE) were investigated for improvement of intergranular corrosion resistance of type 304 austenitic stainless steel. The grain boundary character distribution (GBCD) was examined by orientation imaging microscopy (OIM). The intergranular corrosion resistance was evaluated by electrochemical potentiokinetic reactivation (EPR) and ferric sulfate-sulfuric acid tests. The sensitivity to intergranular corrosion was reduced by the thermomechanical treatment and indicated a minimum at a small roll-reduction. The frequency of coincidence-site-lattice (CSL) boundaries indicated a maximum at the small pre-strain. The ferric sulfate-sulfuric acid test showed much smaller corrosion rate in the thermomechanical-treated specimen than in the base material for long time sensitization. The optimum thermomechanical treatment introduced a high frequency of CSL boundaries and the clear discontinuity of corrosive random boundary network in the material, and resulted in the high intergranular corrosion resistance arresting the propagation of intergranular corrosion from the surface.