Papers by Keyword: Direct Shear Apparatus

Abstract: The unconsolidated-undrained fast shear tests of saturated-unsaturated remolded soil samples under different moisture content which is 1.1%, 10.1%, 14.9%, 19.9%, 24.2%, 29.9%, 37.7% respectively, and normal stress which is 50kPa, 100kPa, 200kPa, 300kPa, 400kPa respectively, were studied by the modified SDJ-1-type strain direct shear apparatus and U.S. Lab VIEW data acquisition system. The shear strength parameters of unsaturated soil samples, i.e. general cohesion and general internal friction angle were obtained based on Mohr-Coulomb strength theory. The test results showed that the general cohesion firstly increased and then reduced with the moisture content increasing, and the general internal friction angle increased with the moisture content decreasing. The function between the general shear strength parameters and the moisture content was studied. The concept of general shear strength parameters was proposed in the paper, and would provide a simple and practical method to obtain the strength parameters for engineering practice.

Abstract: The dynamic parameters of the permafrost are very important for engineering design, also using in the numerical calculation. The dynamic parameters directly affect the correctness of engineering design and numerical simulation. Beijing Jiaotong University developed a novel dynamic load direct shear apparatus to measure these parameters. In the paper, it is analyzed Power systems, measurement and control systems of the dynamic load direct shear apparatus, and gave a verification experiment, the results show that dynamic load direct shear apparatus can complete its purpose.

Abstract: The powder with size distribution was made from eruption to be used for the simulant of lunar soil. One of the most important factors is shear property, to simulate lunar soil behavior under the rover wheels. Therefore, it is necessary to measure the shear parameters of the simulant. The direct shear detector with controlled sample weight was used for selecting suitable method to obtain the shear parameters of the simulant, and finding effect actors for the measurement. Results found that the parameters changed greatly with the powder bulk density (or unit weight), and the calibration was vitally important for measuring cohesion of the powder.