Papers by Keyword: Dislocation Climb

Abstract: Large-strain deformation of aluminum in shear consistently evinces strain softening of roughly 15-20%. Most researchers have suggested that this flow stress decrease is a consequence of a decrease in the average Taylor factor as a consequence of a shear-texture. The authors also consider, now, the possibility that changes in the dislocation climb stress induced by the texture could rationalize the softening. This work reports on an analysis of large strain deformation of aluminum single crystals in the softest orientation {111} <110>. Here softening is not observed. However, this result and other in earlier publications are consistent with dislocation climb being the rate-controlling process that also explains the observed stress versus strain behavior.

Abstract: Creep behavior of AM50-0.4% Sb-0.9%Gd alloy has been studied at temperatures ranging from 150 to 200°C and at stresses ranging from 40 to 90 MPa. Results show that the creep rate of AM50-0.4%Sb-0.9%Gd alloy was mainly controlled by dislocation climb at low stresses under 50 MPa. The activation energy for the creep was 131.2 ± 10 kJ/mol and the stress exponent was in the range from 4 to 9 depending on the applied stress. More than one deformation-mechanism were involved during the creep of this alloy. Microstructures of the alloy consist of a–Mg matrix and fine particles, distinguished as Mg17Al12, Sb2Mg3, and Mg2Gd or Al7GdMn5 that were homogeneously distributed in the matrix of the alloy, which effectively reduced the movement of dislocations, enhancing the creep resistance. Many dislocations were identified to be present on non-basal planes after creep deformation.