Papers by Keyword: Gas Foaming

Abstract: Microwave heating was used with a gas foaming method for fabricating limestone carbonated hydroxyapatite scaffold (SCHA). Carbonated hydroxyapatite (CHA) was produced from limestone as a calcium source using the co-precipitation method. For further treatment, 0.6 gr CHA powder was mixed in 1 ml H₂O₂ solution as a blowing agent. The slurry-foam-like CHA was heated in a microwave with different levels of heating power from 180 W to 720 W. The SCHA samples were characterized using X-ray diffraction (XRD), Fourier-transform infrared (FTIR), and Scanning electron microscope (SEM). The crystallinity and crystallite size were affected due to different rates of heating power in the microwave-assisted method. The increasing temperature decreased the crystallite size from 37.49 to 33.97(nm). However, other crystallinity trends were observed at 180 W because the lower power heating needed a longer time to be formed SCHA. The different power rates have an insignificant contribution to the morphology of the scaffolds.

Abstract: Hydroxyapatite/polymer scaffolds with proper biomechanical properties and stable 3-D porous structure were fabricated by combining gas foaming with solvent-casting/particle-leaching technique, in which novel solid H2O2 were used as a porogen. During the manufacturing process, we found that the porosity, compressive strength and microstructure of the composites are varied from each other while different solvents (dichloromethane, acetone, chloroform and 1,4-dioxane) were used. Porosities of the specimens increase from 72±5 to 87±5% in accordance with the increase of boiling point from 39.75 to 101.32 °C, while compressive strength decreased (4.8±0.7- 0.5±0.3 MPa). Interactions of HA/solvent and PLA/solvent together with evaporation dynamic tests of different solvents were investigated. The results show that the evaporation rate of the solvents is the most important factor affecting the final properties of the scaffolds.