Papers by Keyword: Grinding Area

Abstract: Grinding is often to use the grinding fluid because of the high temperature in the grinding area. During the process of grinding, which is used traditional way of grinding fluid supply, gas barrier layer which around high-speed rotary wheel impeded effective grinding fluid into grinding zone, so it creates huge waste and pollution. Minimum quantity lubricant (MQL) grinding as a way of Green Manufacturing is proposed in recent years. So far, the problem of MQL can be applied in grinding has not been confirmed. In this paper, the applicability of MQL in grinding is studied by comparing the experiment of traditional grinding fluid supply method, minimum quantity lubricant grinding method and dry grinding method, and this study is based on theoretical analysis of minimum quantity lubricant grinding.

Abstract: Grinding temperature is the main factor to limit the improvement of grinding efficiency. The main reason of grinding temperature rise is amount of heat transfer into the workpiece in grinding process. How to determine the proportion ratio, which heat transfers into the workpiece, is the main research issue to the precise machining scholars. In this paper, the heat resistance model is used to analyze the proportional coefficient about how much heat transfer into the grinding wheel, and the factors which to influence this coefficient are discussed. The moving heat source method is used to calculate the temperature field caused by single grain heat source, and the heat integral method is used to calculate the heat contains by the grinding chip, and then the heat proportional coefficients transferring into the chip and workpiece are determined respectively.