Papers by Keyword: High Energy

Abstract: Reducing the network energy consumption and increasing the lifetime of network are important content for wireless sensor network. LEACH is an adaptive routing algorithm with low consumption for wireless sensor network. However there are many shortcomings in LEACH routing algorithm such as too much energy consumption of cluster heads and uneven clustering each round. This paper puts forward a new improved algorithm named H-LEACH to solve the problem above. It lets the nodes holding more energy have the high possibility to become cluster-heads through a threshold and constraints the number of clusters each round at the same time so that it can balance the energy distribution and reduce energy cost. Simulation results show that H-LEACH is more energy-efficient than LEACH protocol.

Abstract: To break through the drawbacks of the one-mass vibrating screen like plugging screen, high noise and etc., a new vibration screen with two-mass and high energy which could generate transient high vibration intensity was analyzed. To meet the requirements of energy-saving and system stability, a spring with nonlinear and hard features was used in the main vibration system. In this case, the springs stiffness could change along with the vibration intensity. The stiffness of the vibration isolation spring could be determined by analyzing the vibration isolation coefficient, and then the hollow cylindrical rubber spring with internal damping was adopted in the vibration isolation system. On the one hand, this vibration isolation spring could effectively absorb transient high vibration intensity which passed from main vibrating spring to the lower mass. On the other hand, it could achieve good effect of vibration isolation between the lower mass and the foundation. Base on field testing, the vibration intensity was increased by 28%, meanwhile, the noise was reduced by 4% and the impact vibration to foundation was reduced by 24% , which successfully solved the plugging screen problem and also verified the validity of the vibration isolation system.

Abstract: As the several speeds up of railway, the operated speed is more than 300km/h, and it is a serious challenge to the safe. So, bring in the high energy radiographic testing is significative. It introduces the NDT method in railway industry, and the advantage of high energy radiographic testing, and introduces several testing results of high energy radiographic testing in swing set, shows the testing is a good method to the Non-destructive testing.

Abstract: Magnetic nanoparticles are materials of great interest because of the remarkable fundamental properties exhibited by these materials as well as their technological potential in the area of biomedicine and other areas. The technologically useful properties of magnetic nanomaterials are not limited to their structural, chemical or mechanical behaviour, but also involve the phenomena that arise from their finite size and the surface effects that dominate the magnetic behaviour of individual nanoparticles. New techniques that have been developed recently have permitted researchers to produce larger quantities of nanomaterials and characterize them better. Here, some of the most promising procedures are reported, including techniques based on hydrothermal syntheses, sol-gel syntheses, co-precipitation syntheses, mechanochemical syntheses, sonochemical syntheses, spray pyrolysis and microemulsion-assisted syntheses.