Papers by Keyword: High Speed Dry Cutting

Abstract: In this paper, based on the experiments of high speed dry cutting nickel alloyed ductile iron with different nickel contents by graded ceramic tool, the cutting performance and wear mechanisms of graded ceramic tool were investigated. Results reveal that with the increase of cutting speed and nickel content the wear of graded ceramic tool is increased, wear mechanisms are transformated spalling and cohesive wear from abrasive wear, and chip shapes are turned into long arc segment from short segment.

Abstract: The high-speed hard and dry cutting chips of hardened alloy-steel with PCBN tool is presented in this paper: After the work piece temperature measured by ThermaVision infrared thermometer, it is proved that the heat generated by cutting is carried out by chips; After SEM analyzed chip it is proved that the cutting temperature is increased and then fallen and the PCBN tool suitable for high-speed hard and dry cutting. It is suitable for PCBN tool cutting hardened alloy-steel 42CrMo instead of grinding.

Abstract: This paper deals with the High-speed Hard and Dry Cutting mechanism of hardened alloy-steel with PCBN tool: the cutting speed and workpieces temperature and tool wear are being discussed in different cutting speeds when cutting alloy-steel 42CrMo. After the workpiece temperature measured by ThermaVision, it is proved that the workpiece temperature was not high and changed little. Through the SEM and EDS analyses for chip and tool wear, it is proved that PCBN tool is suitable for High-speed Hard and Dry Cutting. It is suitable for PCBN tool to cut hardened alloy-steel 42CrMo instead of grinding.