Papers by Keyword: Incremental Hole Drilling

Abstract: Residual stress measurements are very challenging in thin aluminium plates. Rolling-induced crystallographic texture can lead to an S-shape fit when using the sin²ψ method for surface X-ray diffraction. Peak broadening and missing peaks can also be observed for synchrotron X-ray diffraction with conventional θ/2θ scanning due to texture. In addition, when measuring near the plate surfaces, partially-filled gauge volumes in diffraction experiments will lead to “pseudo-strains”, an apparent shift between measured and actual positions for the diffraction peak. Obtaining a meaningful value of d0 for strain calculations is another issue for diffraction experiments in thin plates. The low thickness also offers challenges for destructive methods including incremental hole drilling, i.e. there is no defined ASTM standard for measuring non-uniform residual stress profile for thin plates. In this work, 2-mm-thick Al2024-T351 plate was investigated for residual stress fields due to laser peening. Neutron diffraction measurements were carried out at POLDI (Pulse Overlap time-of-flight Diffractometer) in PSI, Switzerland and the results are compared with incremental hole drilling.

Abstract: The measurement of residual stress using the incremental hole drilling is well established, but the main limitations with the conventional strain gauge approach are the requirements for surface preparation, the need for accurate alignment and drilling, the restricted range of hole geometries commensurate with the specific gauge designs, and the limited range of strain data averaged over the footprint of the strain gauge grid. Recent attempts to extend the method have seen the application of full field optical techniques such as electronic speckle pattern interferometry and holographic interferometry for measuring the strain fields around the hole, but these methods are sensitive to vibration and this limits their practical use to controlled laboratory environments. There are significant potential benefits therefore of using a more robust technique based on Digital Image Correlation (DIC), and work is presented in this study on the development of the method for measuring surface displacements and strain fields generated during incremental hole drilling. Some of the practical issues associated with the technique development, including the optimization of applied patterns, the development of the optical system and integration with current hole drilling equipment are discussed, and although measurements are only presented for a single load case - the equi-biaxial stress state introduced during shot peening - the novel aspect of this work is the integration of DIC measurements with incremental drilling and an application of the Integral Method analysis to measure the variation of residual stress with depth. Validation data comparing results from conventional strain gauge data and FE models is also presented.