Papers by Keyword: Meta-Stable β Titanium

Abstract: The Young’s modulus of Ti-Cr-Sn-Zr alloy varies with the composition of Cr, Sn and Zr, in which the elements act as β stabilizers. Some Ti-Cr-Sn-Zr alloys show very low Young’s modulus under 50GPa. The amount of Zr in alloys with very low Young's modulus increases with the decrease of Cr. We investigated the Young’s modulus and deformation behavior of Ti-xCr-Sn-Zr (x=0~1mass%) alloys containing a large amount of Zr. The quenched microstructure of Ti-Cr-Sn-Zr alloys changes from martensitic structure to β single-phase structure if the amounts of β stabilized elements are increased. The Ti-Cr-Sn-Zr alloys with compositions close to the transitional composition of microstructure from martensite to β phase show minimum Young’s modulus. The clear microstructural transition disappears and the minimum Young’s modulus increases if the amount of Cr becomes too small. In Ti-Cr-Sn-Zr alloys containing a large amount of Zr, Young’s modulus depends on β phase that is intermingled with martensite.

Abstract: This work investigates the mechanical properties of Ti-Cr-Sn-Zr alloys containing large amount of Zr. We focuses on the effect of the varying alloy composition on the microstructure, the Young’s modulus, the deformation mechanism and the deformation behavior. Ti-Cr-Sn-Zr alloys show much low Young’s modulus in the narrow composition range for Cr but wide for Zr. The Young’s modulus of Ti-2Cr-6Sn-xZr (x=5~60mass%) alloy decreases with increasing Zr and shows the minimum value of 41GPa in Ti-2Cr-6Sn-45Zr alloy. The alloys with low Young’s modulus consist in meta-stable β phase. The composition of the meta-stable β phase is close to the transition where the quenched microstructure transits from martensite to meta-stable β phase. Ti-2Cr-6Sn-45Zr alloy with lowest Young’s modulus show the super-elastic property.

Abstract: This work investigates the mechanical properties of Ti-Cr system alloys and focuses on the microstructure, the Young’s modulus, the deformation mechanism and the deformation behaviour observed in various alloy compositions. The addition of Al to the Ti-Cr system alloys greatly decreases the Young’s modulus. Addition of Al, Sn and Zr to various Ti-Cr alloys suppresses the athermal ω phase that forms during quenching from β field. A Ti-Cr system alloy with low Young’s modulus was obtained in suitable compositional combination of Cr, Zr and Sn or Al. The alloys with the composition where the quenched microstructure transits from martensite to meta-stable β phase show low Young’s modulus. In addition, the alloys show two-step yielding due to stress-induced transformation.

Abstract: Low modulus β Ti alloys are attractive for biomedical application. This work examines the mechanical properties of Ti-Cr-Sn-Zr system alloys, especially the effect of the varying alloy composition on the microstructure, the Young’s modulus and the deformation mechanism.The Young’s modulus of the alloy varies with the composition, which variation is caused mainly from the competition between the meta-stable β phase and ω phase.The deformation modes of the Ti-Cr-Sn-Zr alloy, which are the mechanical twinning, the deformation by slip and the deformation-induced transformation, also change depending on the composition of the alloy. The minimum of the Young’s modulusof the Ti-Cr-Sn-Zr alloy in this experiment was shown in the composition where the microstructure of the alloy changes from the martensitic structure to the meta-stable β structure.