Papers by Keyword: Mg-Al-Ca

Abstract: Hot cracking of ternary Mg-Al-Ca alloys in permanent mold casting was studied. The alloys are the base of some potential creep-resistant Mg alloys. The Mg-xAl-yCa alloys included Mg-4Al-1Ca, Mg-4Al-2Ca, Mg-4Al-3Ca, Mg-4Al-4Ca, Mg-5Al-3Ca, and Mg-6Al-3Ca. Constrained-rod casting was conducted with a steel mold. Rods were cast with their ends enlarged to act as anchors, which kept the rods from free contraction and thus induced tension in the rods to cause cracking during solidification. The susceptibility to hot cracking was evaluated based on both the widths and locations of cracks in the resultant castings. Both binary Mg-4Al and commercial alloy AZ91E, which is known to have a low susceptibility to hot cracking, were also included for comparison. It was found that within the composition range studied, the crack susceptibility decreased significantly with increasing Ca content (y) but did not change much with the Al content (x).