Papers by Keyword: Micro-Stress

Abstract: YSZ/Al2O3 composite coatings have been fabricated by using EPD. The microstructures, mechanical properties and micro-stresses of the coatings produced from different sized powders and sintered at different temperatures have been studied. Different attrition milling time leads to different particle distribution modes, thereby different microstructures. Due to the deposition process and the constraint effect from the substrate, a gradient structure has been formed across the coating thickness.

Abstract: The aim of the present paper is that, utilizing finite element method, considering the influence of different length of CNTs and different strength of interface to investigate the micro stress distribution of CNT reinforced magnesium matrix composite. When analyzing, the material character of magnesium is regarded as anisotropic. Utilizing the primary theory to calculate the anisotropic elasticity modulus; Define the reasonable length of CNTs; Considering the influence on the micro stress distribution of different interface strength.

Abstract: For investigating the twinning and detwinning behaviour under cyclic loading conditions in-situ stress measurements with different applied strain amplitudes were performed at the beamline 7T-MPW at BESSY II. Intensity measurements of the (10-10), (11-20) and (0002) reflections served for the determination of the twinned volume fraction. The measurements of the (hkil) dependent strains and stresses gave information on the load partitioning between different grain orientations. The intensity measurements performed in the compression regime showed that the evolution of the (0002) reflection intensity depends on the strain amplitude. For strain amplitudes ≥ 0.75 % an increase in intensity is observed whereas for smaller strain amplitudes the (0002) intensity decreases with increasing cycle numbers. In the tensile regime an increase in the (0002) reflection intensity is found for the whole range of applied strain amplitudes.