Papers by Keyword: Phosphorous Slag Powder

Abstract: Reactive powder concrete (RPC) is an ultra-high performance concrete (UHPC). Cement and silica fume content of RPC are generally rather high compared to the conventional concrete. The aim of this paper is to decrease the cement content of RPC by using phosphorous slag powder. Firstly the effect of grinding time on the activity index of phosphorous slag was investigated. And then, the mix proportion design of this UHPC containing phosphorous slag powder and silica fume was done through orthogonal design. The results indicate that the utilization of phosphorous slag powder in RPC is feasible when the dosage of phosphorous slag powder is about 35% (by weight of the binder) and the water-binder ratio is less than 0.18. By substituting phosphorous slag powder for a part of cement and keeping the water-binder ratio at about 0.14, UHPC specimens whose content of mineral admixtures, including phosphorous slag powder and silica fume, was about 40%~50% (by weight of the binder) were obtained after they had been cured in 80 °C water for 72 hours. The compressive and flexural strength of those specimens was more than 150 MPa and 20 MPa respectively.

Abstract: This paper presents the results of laboratory and outdoor exposure site studies on belite-rich cement concrete with phosphorous slag powder and fly ash. The parameters studied included strength, hydration heat, ultimate elongation, Young’s modulus, and adiabatic in temperature. The experimental results showed that belite-rich cement resulted in a higher rate of strength development of mortar and concrete at later ages when compared with that of moderate-heat Portland cement. And the hydration heat of belite-rich cement is lower than that of reference. This is due to the different phase composition of the two cements. Belite-rich cement contains less C₃S but more C₂S than moderate-heat Portland cement. In addition, belite-rich cement concrete with phosphorous slag powder and fly ash exhibited better performances than those of moderate-heat Portland cement concrete.

Abstract: The present study aims to investigate the opportunity to largely substitute low heat Portland cement of mass concrete with supplementary cementitious materials. The pozzolanic reaction of two types of supplementary cementitious materials, phosphorous slag powder and fly ash , were determined by X-ray diffraction, differential thermal analysis–thermogravimetry and scanning electron microscopy from 28 to 90 days. The properties of mortar and mass concrete containing 30% of supplementary cementitious materials were also investigated. Results showed that supplementary cementitious materials could decrease the amount of calcium hydroxide, fill the capillary pores, thus making the mortar and mass concrete more compact and durable. Long-term strength of mass concrete containing 30% of supplementary cementitious materials were comparable (or even better) than the control concrete (without supplementary cementitious materials) at constant workability, while the Young’s modulus was lower than the control concrete.