Papers by Keyword: Pinus Cembra Sibirica

Abstract: Pinus has been put into mass production. However, many heat release volatiles would produce air pollution during drying process. Therefore, the heat release behavior of Pinus biomass was studied by TD-GC/MS. The main constituents were at 100°С 1,4-methanoazulene,decahydro-4,8, 8-trimethyl-9-methylene-(30.6%), 1,4-methanoazulen-9-ol,decahydro-1,5,5,8a-tetramethyl-(14.85%), 1,2,4-methenoazulene, decahydro-1,5,5,8a-tetramethyl-(8.56%), 1r-.alpha.-pinene(7.92%), epiglobulol(4.57%), bicyclo[2.2.1]heptan- 2-one, 1,7,7- trimethyl-, (1r)- (4.33%), caryophyllene oxide(3.37%), etc. And the main constituents at 110°С were 1,4-methanoazulene, decahydro-4,8, 8-trimethyl-9-methylene-(40.31%), 1,4-methanoazulen-9-ol, decahydro-1,5,5,8a-tetramethyl-(15.35%), .alpha.-pinene(8.88%), bicyclo [2.2.1]heptan-2-one, 1,7,7- trimethyl-, (1r)- (5.73%), cyclohexane-1,3-dione, 2-allylamin omethylene-5,5-dimethyl-(5.24%), naphthalene, 1,1'-(1,2-ethanediyl) bis[decahydro-(4.83%), spiro[5.5]undec-2-ene,3,7,7-trime thyl-11-methylene-(4.05%), etc. The heat release volatiles of Pinus biomass was safe to people during drying process.

Abstract: Strength values of the sapwood of Siberian yellow pine were measured in a system with orthogonal coordinates along the axial, radial, and tangential directions of the cell structure. Highest strength was the axial normal strength and lowest the tangential normal strength. The difference between these two values was 87-fold. Shear strength values remained between the two normal strength values. The highest shear strength appeared in tangential direction across the reinforcing fibers, i.e., on the plane perpendicular to the axial direction. Lowest shear strength appeared in tangential direction on the plane perpendicular to radial direction. The variations are due to orientation of cells and of fiber reinforcement in the cell wall laminas, especially in the middle layer of the secondary cell wall.