Papers by Keyword: Real Structure

Abstract: In the present contribution the results of the high-resolution X-ray diffraction and X-ray glancing-incidence mirror reflection studies of structural characteristics of the quantum-well GaAs/Ga1-xInxAs/GaAs diluted magnetic semiconductors (DMSC) are presented. The influence of the real structure of the samples on their electro-physical properties is discussed.

Abstract: The real structure of nanocrystalline CeO2-ZrO2 (Ce:Zr=1:1) systems prepared via the polymerized polyester precursor (Pechini) route and doped with La3+ or Gd3+ cations, up to 30 at.%, was studied by X-ray powder diffraction, EXAFS and Raman spectroscopy and the surface features characterized by XPS and SIMS. Undoped CeO2-ZrO2 system revealed nanoscale heterogeneity, perhaps due to the co-existence of Zr- or Ce-enriched domains. With large La3+ dopant the system remains bi-phasic within the studied ranges of composition, incorporation of the smaller Gd3+ cation stabilizes the single-phase solid solution. For both systems, the increase of dopant content was accompanied by a decline of domain size and an increase of the average lattice parameter of fluorite-like phases. Depletion of the surface layer by smaller Zr4+ cations was observed, while the surface content of a doping cation is either, close to that in the bulk (La) or below it (Gd). Such a spatial distribution of components results in some ordering of cations within the lattice. It is reflected in different modes of rearrangement of oxygen coordination polyhedra with the Gd or La content (distances and coordination numbers by EXAFS), and specificity of XRD patterns not conforming to a simple model with statistical distribution of oxygen vacancies.

Abstract: Tests on shaking table have been carried out on a 3D full scale infilled r.c. frame specimen (55 tons). These tests have been performed by the EMSI Laboratory of C.E.A. Saclay (France) together with a research team of the Universities of Chieti-Pescara (Italy), Roma Tre (Italy) and Patras (Greece). These tests are included in Ecoleader European research program. Many characterization tests of infill components (mortar and bricks) have been performed in the SCAM Laboratory of the University of Chieti-Pescara while tests on masonry walls were made in the laboratory of University of Rome 3. The structure represents the first floor of a two floors frame structure previously tested. The mockup is a full-scale one storey rc infilled frame with four columns, 3 meters high, with about 4 meters side square floor and infilled with double bricks wall. The main aim is to get information about the behavior of real structures. The instrumentation with about one hundred channels was set up to measure the rc frame response and the different behavior of the double walls during the tests. First, monodirectional and bidirectional tests at low seismic intensity (0.10 g and 0.15 g PGA levels) have been performed on the bare frame in order to characterize its structural characteristics and to check the design provisions. Then, the bare frame has been infilled and other tests have carried out at increasing seismic intensity in order to define its serviceability and ultimate limit states. Monodirectional and bidirectional tests up to 0.45 g PGA level were carried out. The last sequence included a monodirectional test on the infilled frame with only two walls. The high seismic input (0.55 g PGA level) was parallel to the direction of the walls. In this paper, research program and some main test results are presented.