Papers by Keyword: Residual Stock Removal

Abstract: In micro endmilling, because of small uncut chip thickness comparable to the tool edge radius and low rigidity of tool, the cutting process must frequently transit between rubbing/ploughing and cutting, and it may deteriorate the machining stability, surface finish and tool wear. In this report, such unique cutting phenomena are investigated by modeling a mechanism, computer simulations and experiments. As a result, a possibility of the unique cutting phenomena proposed has been certified.

Abstract: Usually, the contact stiffness between a grinding wheel and a workpiece has been measured in a stationary state. So, in this study, the contact stiffness under the grinding operation is measured under different table feed rate of the workpiece. From this result, it is known that, while the contact stiffness in the stationary state increases with the increase of the contact force, the contact stiffness under the grinding operation decreases with the increase of the normal grinding force relating the table feed rate. In this paper, since the number of contacting abrasive grain with workpiece is constant irrespective of the table feed rate, and the residual stock removal of workpiece is varied by the table feed rate, it is clarified that the contact stiffness under the grinding operation differs from the contact stiffness measured by the stationary state.