Papers by Keyword: UV-Light Irradiation

Abstract: Surface properties of a material play a significant role in manipulating biological response of living body to artificial materials. The aim of this work was put on bioactivity assessment of TiO₂ ceramic after thermal treatment and further surface activation with UV-light. The in vitro apatite-forming ability was examined by soaking the samples into the simulated body fluid for several days. The research shows that nanostructural surface and UV irradiation accelerates formation of apatite on TiO₂ pellets.

Abstract: A recently developed “GRAPE^® technology” provides titanium or titanium alloy implants with spontaneous apatite-forming ability in vitro, which requires properly designed gaps and optimum heat treatment in air. In this study, pure titanium pieces were thermally oxidized in air and pre-irradiated by UV-light under different environmental conditions such as in air or in ultra-pure water before aligning pairs of specimens in the GRAPE^® set-up, i.e., two pieces of titanium substrates were aligned parallel to each other with optimum gap width (spatial design). Then, they were soaked in Kokubo’s simulated body fluid (SBF, pH7.4, 36.5°C) for 1-2 days to clarify how the UV-light pre-irradiation affects the in vitro apatite nucleation on the substrates under the specific spatial design. UV-light pre-irradiation in water led to the deposition of a large number of apatite particles within 1 day, and showed apatite X-ray diffraction, although UV-light pre-irradiation in air and non-pretreated specimens gave the deposition of a few apatite particles and did not show any apatite X-ray diffraction. These results indicated that the rate of primary heterogeneous nucleation of apatite increased by UV-light pre-irradiation in ultra-pure water. TF-XRD patterns of the surface of the substrates thermally oxidized in air at 500°C showed the peak at 2θ = 27º assignable to the 110 diffraction of rutile phase of titanium dioxide (ICDD-JCPDS data #21-1276). Previous studies reported that the primary heterogeneous nucleation must be induced by Ti-OH groups on titanium oxide layer. Probably, the UV-light pre-irradiation in ultra-pure water can increase the number of Ti-OH groups on the surface, resulting in accelerated primary heterogeneous nucleation of apatite.