A Study of Cutting State Monitoring System Based on Virtual Instrument


Article Preview

This study takes virtual instrument technology as the development platform to complete data acquisition, pre-processing, analysis and database storage for three orthogonal components of a cutting force and the corresponding cutting temperature. Simultaneously, single-factor experimentation is adopted to establish empirical formulas of these cutting state parameters for further check analysis. Hence real-time monitoring of cutting process can be implemented to represent cutting-tool wear, failure and rationality of parameter selection in cutting state.



Edited by:

Kai Cheng, Yingxue Yao and Liang Zhou




C. Y. Wu et al., "A Study of Cutting State Monitoring System Based on Virtual Instrument", Applied Mechanics and Materials, Vols. 10-12, pp. 568-572, 2008

Online since:

December 2007




[1] X.Y. Wang: Tool Engineering, Vol. 37 (2003), p.50.

[2] Z.Q. Liu, C.Z. Huang and X. Ai: Tool Engineering, Vol. 36 (2002), p.2.

[3] J. Lin and C.Y. Liu: Measurement Science and Technology, Vol. 12 (2001).

[4] X.L. Liu and Z.J. Yuan: Acta Metrologica Sinica, Vol. 20 (1999), p.187.

[5] H.S. Ding and S.W. Bai: submitted to Journal of Test and Measurement Technology, (2005).

Fetching data from Crossref.
This may take some time to load.