On the Basis of Double Fuzzy Control of Honing Machine Reciprocating Motion


Article Preview

This paper mainly researches the control system of honing machine spindle reciprocating motion. On the basis of brief introduction to the processing of honing machines, its mathematic models were established, and design the double control system on the base of fuzzy control .Two fuzzy controllers were used separately according to actual error signal of the system output to improve the system rapidity and overshot .so that make the designed control system of honing machines spindle reciprocating motion can satisfy the design requirements better. Finally the control system was conducted by using the tool of MATLAB. The simulation result showed that the double fuzzy controller can effectively reduce steady-state error of the system and overshoots can well satisfied the system performance index, and has some quick response ability.



Edited by:

Chunliang Zhang and Paul P. Lin




C. B. Hu et al., "On the Basis of Double Fuzzy Control of Honing Machine Reciprocating Motion", Applied Mechanics and Materials, Vols. 226-228, pp. 820-824, 2012

Online since:

November 2012




[1] J.M. WU: Key Technical Researches on Numerical Control Honing Machine (MS., Lanzhou University of Technology, China 2005), p.3. (In Chinese).

[2] F.B. LAI: Research on High-speed Numerical Control Honing Machine Control System (MS., Lanzhou University of Technology, China 2005), p.27. (In Chinese).

[3] R.C. FENG,B. LIU,Z.Y. RUI: Modular Machine and Automatic Manufacturing Technique, Vol. 22(2005)No. 6. p.22(In Chinese).

[4] N.I. ZHOU: Electronic Design Engineering, Vol. 19(2011)No. 3, p.65(In Chinese).

[5] G.Y. LI, Journal of System Simulation, Vol. 15 (2003) No. 10, p.1492(In Chinese).

[6] Q.M. CHENG,Y.H. WANG: Journal of Shanghai University of Electric Power, Vol. 22 (2006) No. 2. p.105(In Chinese).