Determining the Exact Value of the Shape Deviations of the Experimental Measurements


Article Preview

The paper also says about practical measuring geometrical deviations by commonly used tools. Also deals with an analysis of geometric deviations, reasons of their generation and provides their brief description. It points at ways and abilities of measuring shape deviations by means of contact and contactless measuring methods and deals with errors which can affect results of measuring. It evaluates and analyses ability of measuring by various devices. It shows a review of individual measured values and thus provides a view of efficiency, simplicity and accuracy of individual measuring devices and measuring methods.



Edited by:

Li Qiang




J. Maščeník and S. Pavlenko, "Determining the Exact Value of the Shape Deviations of the Experimental Measurements", Applied Mechanics and Materials, Vol. 624, pp. 339-343, 2014

Online since:

August 2014




* - Corresponding Author

[1] L. Bicejova: Water jet technology head vibration generation due to selected technology parameters fluctuation effect during alloy cutting, In: Applied Mechanics and Materials. Vol. 308 (2013), pp.81-86. ISSN 1660-9336.


[2] S. Gaspar, J. Pasko: Influence of technological factors of die casting on mechanical properties of castings from silumin, 2013. In: Lecture Notes in Electrical Engineering. Vol. 240, pp.713-722, ISSN 1876-1100.

[3] I. Vojtko, R. Matija, J. Haľko, L. Mišík: Group technology in design of production method, In: 23. microCAD. section M, Production engineering and manufacturing systems, Miskolc: University of Miskolc, 2009 pp.245-248, ISBN 978963661878.

[4] Z. Murčinková, T. Krenický: Implementation of virtual instrumentation for multiparametric technical system monitoring, In: SGEM 2013 : 13th international multidisciplinary scientific geoconference : Informatics, geoinformatics and remote sensing, 2013, Bulgaria - Sofia : STEF92 Technology, pp.139-144.

[5] J. Mascenik, S. Pavlenko, L. Bicejova: Component Selected Parametres Geometrical Tolerance Value Experimental Specification, 2013. In: Applied Mechanics and Materials. Vol. 389, ISSN 1660-9336.


[6] J. Mascenik, S. Gaspar: Experimental Assessment of Roughness Changes in the Cutting Surface and Microhardness Changes of the Material S 355 J2 G3 after Being Cut by Non-Conventional Technologies, 2011. In: Advanced Materials Research. Vol. 314-316, ISSN 1022-6680.