The Research of the Non-Circular Contour Grinding Speed Optimization and NC Programming

Abstract:

Article Preview

In non-circular contour grinding process, a theoretical model of constant linear velocity grinding has been established based on the X-C Axis linkage motion principle of grinding machine. Based on this theoretical model, a numerical calculation model, which can be used for practical grinding process and can optimize and regulate the grinding speed, has be built by way of cubic spline fitting interpolation method. The calculated numerical result of this model can switch into NC code of some NC system. According to the motion principle of grinding machine, the geometry information of specific non-circle contour part and the real parameter of the grinding processing plan, the corresponding NC Programming function also has been modularized. An experiment has been done on the NC high speed camshaft grinding machine type of CNC8312A, and obtained the ideal processing effect.At the same time ,it also shows that the proposed method has strong practical feasibility and great practical value.

Info:

Periodical:

Edited by:

Fangping Zhang

Pages:

229-234

Citation:

D. F. Cao and J. N. Duan, "The Research of the Non-Circular Contour Grinding Speed Optimization and NC Programming", Applied Mechanics and Materials, Vol. 628, pp. 229-234, 2014

Online since:

September 2014

Export:

Price:

$38.00

* - Corresponding Author

[1] LUOHong-ping, ZHOUZhi-xiong. Tactics on Grinding of Camshaft Part by Using Method of Tracing Tangent Point Grinding. Journal of Hunan University(Natural Sciences Edition), 2002,29(6): 61-66.

[2] DENGZhao-hu, WANGJuan, CAODe-fang. Dynamic Optimization and Simulation of Camshaft Grinding Process Journal of Hunan University(Natural Sciences), 2009, 36(5): 21-25.

[3] Cao DF, Deng ZH, Zhang XH. Process Information Parameterization of Camshaft Part for Virtual High-speed Grinding. Advanced Materials Research, 2011, 188: 652-656.

DOI: https://doi.org/10.4028/www.scientific.net/amr.188.652

[4] DENG Zhaohui, ZHANG Xiaohong, CAO Defang. Process Expert System in NC Camshaft Grinding on the Basis of Rough Set and Case-based Reasoning. Journal of mechanical engineering, 2009, 45(6): 211-219.

DOI: https://doi.org/10.3901/jme.2010.21.178

[5] ZH Deng, XH Zhang, W Liu, et al. Process parameters selection in NC camshaft grinding based on uniform design and GA-NN. Advanced Materials Research, 2009, 69-70: 437-441.

DOI: https://doi.org/10.4028/www.scientific.net/amr.69-70.437

[6] Deng ZH, Cao DF, Zhang XH, et al. Application of a Case-Based Process Expert System for NC Camshaft Grinding. Advanced Materials Research, 2010, 126-128 : 127-132.

DOI: https://doi.org/10.4028/www.scientific.net/amr.126-128.127