Analysis of the Workpiece Elastic Deformation Holding in Fixture with High Definition Metrology


Article Preview

The work-piece holding in the fixture will have elastic deformation under the effect of clamping force and the positioning of locators which will lead to poor quality. In this paper, after comparing the advantage of High Definition Metrology (HDM) with the traditional contact measurement metrology, the surface flatness measurement experiment scheme was designed based on HDM. Then, it was optimized with Design of Experiment (DOE). Finally, the work-piece elastic deformation caused by clamping force, its location and support location were analyzed using the case of Aluminum alloy 6061 part.



Advanced Materials Research (Volumes 102-104)

Edited by:

Guozhong Chai, Congda Lu and Donghui Wen




Z. L. Jiang and X. X. Meng, "Analysis of the Workpiece Elastic Deformation Holding in Fixture with High Definition Metrology", Advanced Materials Research, Vols. 102-104, pp. 12-16, 2010

Online since:

March 2010




[1] J.Y.H. Fuh and A.Y.C. Nee: And Manuf., Vol. 4 (1994), pp.307-318.

[2] B. Li and S.N. Melkote: Int J Adv Manuf Technol., Vol. 17 (2001), pp.104-113.

[3] S. Srinath and N.M. Shreyes: Society of manufacturing engineers, (2002), pp.1-8.

[4] W.F. Chen, L.J. Ni, J.B. Xue: Int J Adv Manuf Technol, Vol. 38 (2008), pp.860-867.

[5] http: /www. coherix. com/surface_flatness_measurement_in_precision_manufacturing.

[6] Keun Park and Jong-Ho Ahnb: Journal of Materials Processing Technology, Vol. 146 (2004), pp.221-227 Fig. 5 Contour surface of the flatness.

Fetching data from Crossref.
This may take some time to load.