Research on Temperature Field about Cutting Area in Plunge Milling Ti Alloy Based on Finite Element

Abstract:

Article Preview

Because of the small thermal conductivity coefficient of Ti alloy, the heat cannot disperse timely and accumulate seriously when plunge milling Ti alloy. If the cutting parameters can not be controlled well, the phenomenon of sticking will happen easily. According to the simulation and analysis of temperature field by using finite element software ABAQUS, the influence on cutting speed and feed for the Distributing of Temperature Field about Cutting Area in Plunge Milling Ti Alloy is acquired.

Info:

Periodical:

Advanced Materials Research (Volumes 102-104)

Edited by:

Guozhong Chai, Congda Lu and Donghui Wen

Pages:

630-633

DOI:

10.4028/www.scientific.net/AMR.102-104.630

Citation:

X. D. Qin et al., "Research on Temperature Field about Cutting Area in Plunge Milling Ti Alloy Based on Finite Element", Advanced Materials Research, Vols. 102-104, pp. 630-633, 2010

Online since:

March 2010

Export:

Price:

$35.00

In order to see related information, you need to Login.

In order to see related information, you need to Login.